8/5/2023 0 Comments Pac man plug and play joystickI needed to do some detective work on the cable that went to the neck of the guitar to figure out what wires went to the other buttons. Before you cut the cables, locate the wires to start, back and sync buttons. Disconnect the cable going to the mic from the board all together, and cut off anything connected to the remaining cables. You will not need everything that's connected to the board. Once you have the guitar dismantled, the only part you will need is the board in the upper corner as shown below. Next, remove all 11 Torx T-10 screws from the back. The release for the face plate is on the back, as shown in the images below. Next, remove the batteries and battery cover on the back and front face plate. If you have a broken one with no neck, you can skip this step, too! If you have a neck on yours, you will need to flip the this release lever shown. I found a Guitar off eBay for this without a guitar neck, so I could skip this first part.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |